Belt-drive edge machine with 14 heads!
6 spindles on 1 bridge
Revolutionary double “pre-cut” blades for cutting bevels! full bevel in 1 pass (available on Trident Supreme)
Performs 3cm bullnose at rate of 1 linear foot per minute
Performs 3cm flat polish at rate of 3 linear feet per minute
Full tooling available
Full training and installation from USA technicians
Calibrating wheel for ogee profile capabilities (Optional)
Footprint
17 ft/21 ft long by 7 ft wide by 6 ft high
Motor
6 Motors (1 Diamond and 5 Polishing) Upgradeable to 8 or 10 total
Polished Profiles
Full Bullnose, Half Bullnose, Bevel, Flat Polish, Ogee, Triple Waterfall, Dupont
Blade
3HP Diamond shaping motor & 2HP Abrasive motors
Air
Continuous 125 psi, 10 cfm
Water
45 Gal/Min
Machine Weight
11,000 - 14,000 lbs
Electrical Power
230 Volt 3 Phase 60 Amp
The Trident Edge Polisher performs a 3cm bullnose at the rate of 1 linear foot per minute.
The Trident now offers the special miter cutting feature which allows fabricators to flawlessly execute even miter cuts- even when material is out of thickness calibration.
The Trident Edge Polisher has revolutionary double "pre-cut" blades for cutting bevels. It performs a full bevel in one pass!
The trident is made with only the highest quality components. The conveyor belt is made in Germany and all polishing motors are Italian made. The control system is Allen Bradley - which is one of the finest American brands in the world.
