Start:
October 10, 2023
End:
October 12, 2023
During this training we will cover Wcam commands and drawing basics, Wcam cutting and routing and Q & A on the last day.
Training begins at 9am, at around 12pm we will take a 1hr lunch break, then training continues from 1pm to 4-4:30pm.
Very important to come prepared with a laptop with Wcam software already installed and bring the green USB key. Also bring a notepad to take notes. On the first day of training arrive a little early, to set up and make sure everything's working good on your laptop.
Hotels near to our facility:
Register Now